ELISA Kit for Tyrosol (Tyr)

    • ELISA Kit for Tyrosol (Tyr)Packages (Simulation)
    • ELISA Kit for Tyrosol (Tyr)Packages (Simulation)
    • ELISA Kit for Tyrosol (Tyr)Results demonstration
    • CEO752Ge.jpgTypical Standard Curve
    • CertificateISO9001: 2008, ISO13485: 2003 Registered


    This assay has high sensitivity and excellent specificity for detection of Tyrosol (Tyr).
    No significant cross-reactivity or interference between Tyrosol (Tyr) and analogues was observed.


    Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Tyrosol (Tyr) were tested 20 times on one plate, respectively.
    Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Tyrosol (Tyr) were tested on 3 different plates, 8 replicates in each plate.
    CV(%) = SD/meanX100
    Intra-Assay: CV<10%
    Inter-Assay: CV<12%


    The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
    To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

    Reagents and materials provided

    Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
    Standard2Standard Diluent1×20mL
    Detection Reagent A1×120µLAssay Diluent A1×12mL
    Detection Reagent B1×120µLAssay Diluent B1×12mL
    TMB Substrate1×9mLStop Solution1×6mL
    Wash Buffer (30 × concentrate)1×20mLInstruction manual1

    Assay procedure summary

    1. Prepare all reagents, samples and standards;
    2. Add 50µL standard or sample to each well.
        And then add 50µL prepared Detection Reagent A immediately.
        Shake and mix. Incubate 1 hour at 37°C;
    3. Aspirate and wash 3 times;
    4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
    5. Aspirate and wash 5 times;
    6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
    7. Add 50µL Stop Solution. Read at 450 nm immediately.

    ELISA Kit for Tyrosol (Tyr)

    Test principle

    This assay employs the competitive inhibition enzyme immunoassay technique. A monoclonal antibody specific to Tyrosol (Tyr) has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled Tyrosol (Tyr) and unlabeled Tyrosol (Tyr) (Standards or samples) with the pre-coated antibody specific to Tyrosol (Tyr). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Tyrosol (Tyr) in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of Tyrosol (Tyr) in the sample.

    Related products

    Catalog No.Organism species: Pan-species (General)Applications
    CPO752Ge21OVA Conjugated Tyrosol (Tyr)Immunogen; SDS-PAGE; WB.
    PAO752Ge01Polyclonal Antibody to Tyrosol (Tyr)WB; IHC; ICC; IP.
    CEO752GeELISA Kit for Tyrosol (Tyr)Enzyme-linked immunosorbent assay for Antigen Detection.
    KSO752Ge11ELISA Kit DIY Materials for Tyrosol (Tyr)Main materials for "Do It(ELISA Kit) Yourself"