ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

CXCL1; GRO1; GROa; GRO-A; MGSA-A; NAP3; SCYB1; Chemokine C-X-C-Motif Ligand 1; Melanoma Growth Stimulating Activity Alpha; Fibroblast Secretory Protein

FOR IN VITRO AND RESEARCH USE ONLY, NOT FOR USE IN CLINICAL DIAGNOSTIC PROCEDURES!
  • ELISA Kit for Neutrophil Activating Protein 3 (NAP3)Packages (Simulation)
  • ELISA Kit for Neutrophil Activating Protein 3 (NAP3)Packages (Simulation)
  • ELISA Kit for Neutrophil Activating Protein 3 (NAP3)Results demonstration
  • SEA041Hu.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity

This assay has high sensitivity and excellent specificity for detection of Neutrophil Activating Protein 3 (NAP3).
No significant cross-reactivity or interference between Neutrophil Activating Protein 3 (NAP3) and analogues was observed.

Recovery

Matrices listed below were spiked with certain level of recombinant Neutrophil Activating Protein 3 (NAP3) and the recovery rates were calculated by comparing the measured value to the expected amount of Neutrophil Activating Protein 3 (NAP3) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)97-105101
EDTA plasma(n=5)83-9990
heparin plasma(n=5)92-10195

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Neutrophil Activating Protein 3 (NAP3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Neutrophil Activating Protein 3 (NAP3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Neutrophil Activating Protein 3 (NAP3) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)93-101%90-98%80-93%80-99%
EDTA plasma(n=5)82-98%85-96%89-96%90-104%
heparin plasma(n=5)89-105%80-102%97-105%80-92%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

Test principle

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Neutrophil Activating Protein 3 (NAP3). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Neutrophil Activating Protein 3 (NAP3). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Neutrophil Activating Protein 3 (NAP3), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Neutrophil Activating Protein 3 (NAP3) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No.Organism species: Homo sapiens (Human)Applications
APA041Hu01Active Neutrophil Activating Protein 3 (NAP3)Cell culture; Activity Assays.
RPA041Hu01Recombinant Neutrophil Activating Protein 3 (NAP3)Positive Control; Immunogen; SDS-PAGE; WB.
PAA041Hu01Polyclonal Antibody to Neutrophil Activating Protein 3 (NAP3)WB; ICC; IHC-P; IHC-F; ELISA.
LAA041Hu71Biotin-Linked Polyclonal Antibody to Neutrophil Activating Protein 3 (NAP3)WB; IHC; ICC.
MAA041Hu22Monoclonal Antibody to Neutrophil Activating Protein 3 (NAP3)WB; IHC; ICC; IP.
SEA041HuELISA Kit for Neutrophil Activating Protein 3 (NAP3)Enzyme-linked immunosorbent assay for Antigen Detection.
SCA041HuCLIA Kit for Neutrophil Activating Protein 3 (NAP3)Chemiluminescent immunoassay for Antigen Detection.
KSA041Hu01ELISA Kit DIY Materials for Neutrophil Activating Protein 3 (NAP3)Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK