ELISA Kit for Endothelin Receptor A (ETRA)

EDNRA; ETA; ETR-A; Endothelin A receptor; Endothelin-1 receptor

  • ELISA Kit for Endothelin Receptor A (ETRA) Packages (Simulation)
  • ELISA Kit for Endothelin Receptor A (ETRA) Packages (Simulation)
  • ELISA Kit for Endothelin Receptor A (ETRA) Results demonstration
  • SEB981Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Endothelin Receptor A (ETRA)

This assay has high sensitivity and excellent specificity for detection of Endothelin Receptor A (ETRA).
No significant cross-reactivity or interference between Endothelin Receptor A (ETRA) and analogues was observed.

Precision of the ELISA Kit for Endothelin Receptor A (ETRA)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Endothelin Receptor A (ETRA) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Endothelin Receptor A (ETRA) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability of the ELISA Kit for Endothelin Receptor A (ETRA)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Endothelin Receptor A (ETRA)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Endothelin Receptor A (ETRA)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Endothelin Receptor A (ETRA). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Endothelin Receptor A (ETRA). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Endothelin Receptor A (ETRA), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Endothelin Receptor A (ETRA) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPB981Hu01 Recombinant Endothelin Receptor A (ETRA) Positive Control; Immunogen; SDS-PAGE; WB.
PAB981Hu01 Polyclonal Antibody to Endothelin Receptor A (ETRA) WB; IHC; ICC; IP.
MAB981Hu22 Monoclonal Antibody to Endothelin Receptor A (ETRA) WB; IHC; ICC; IP.
SEB981Hu ELISA Kit for Endothelin Receptor A (ETRA) Enzyme-linked immunosorbent assay for Antigen Detection.
LMB981Hu Multiplex Assay Kit for Endothelin Receptor A (ETRA) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK