ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

ORF9; PANDER; PRED44; C21orf11; C21orf76; Cytokine-like protein 2-21; Pancreatic-derived factor

  • ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B) Packages (Simulation)
  • ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B) Packages (Simulation)
  • ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B) Results demonstration
  • SEL507Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

This assay has high sensitivity and excellent specificity for detection of Family With Sequence Similarity 3, Member B (FAM3B).
No significant cross-reactivity or interference between Family With Sequence Similarity 3, Member B (FAM3B) and analogues was observed.

Recovery of the ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

Matrices listed below were spiked with certain level of recombinant Family With Sequence Similarity 3, Member B (FAM3B) and the recovery rates were calculated by comparing the measured value to the expected amount of Family With Sequence Similarity 3, Member B (FAM3B) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 81-103 87
EDTA plasma(n=5) 80-88 83
heparin plasma(n=5) 90-97 94

Precision of the ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Family With Sequence Similarity 3, Member B (FAM3B) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Family With Sequence Similarity 3, Member B (FAM3B) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Family With Sequence Similarity 3, Member B (FAM3B) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 82-95% 79-94% 93-101% 79-101%
EDTA plasma(n=5) 90-104% 82-96% 96-105% 93-105%
heparin plasma(n=5) 79-102% 79-90% 96-103% 80-91%

Stability of the ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Family With Sequence Similarity 3, Member B (FAM3B). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Family With Sequence Similarity 3, Member B (FAM3B). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Family With Sequence Similarity 3, Member B (FAM3B), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Family With Sequence Similarity 3, Member B (FAM3B) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPL507Hu01 Recombinant Family With Sequence Similarity 3, Member B (FAM3B) Positive Control; Immunogen; SDS-PAGE; WB.
PAL507Hu01 Polyclonal Antibody to Family With Sequence Similarity 3, Member B (FAM3B) WB; IHC; ICC; IP.
MAL507Hu21 Monoclonal Antibody to Family With Sequence Similarity 3, Member B (FAM3B) WB; IHC; ICC; IP.
SEL507Hu ELISA Kit for Family With Sequence Similarity 3, Member B (FAM3B) Enzyme-linked immunosorbent assay for Antigen Detection.
LML507Hu Multiplex Assay Kit for Family With Sequence Similarity 3, Member B (FAM3B) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
PGL507Hu01 Primer Pair for Family With Sequence Similarity 3, Member B (FAM3B) PCR
GUESTBOOK