ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

CAP 57

  • ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI) Packages (Simulation)
  • ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI) Packages (Simulation)
  • ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI) Results demonstration
  • SEB234Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

This assay has high sensitivity and excellent specificity for detection of Bactericidal/Permeability Increasing Protein (BPI).
No significant cross-reactivity or interference between Bactericidal/Permeability Increasing Protein (BPI) and analogues was observed.

Recovery of the ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

Matrices listed below were spiked with certain level of recombinant Bactericidal/Permeability Increasing Protein (BPI) and the recovery rates were calculated by comparing the measured value to the expected amount of Bactericidal/Permeability Increasing Protein (BPI) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 93-101 96
EDTA plasma(n=5) 93-105 97
heparin plasma(n=5) 83-97 87

Precision of the ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Bactericidal/Permeability Increasing Protein (BPI) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Bactericidal/Permeability Increasing Protein (BPI) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Bactericidal/Permeability Increasing Protein (BPI) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 79-92% 84-93% 94-103% 78-105%
EDTA plasma(n=5) 92-99% 89-103% 78-104% 82-101%
heparin plasma(n=5) 92-105% 81-90% 92-101% 93-101%

Stability of the ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Bactericidal/Permeability Increasing Protein (BPI). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Bactericidal/Permeability Increasing Protein (BPI). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Bactericidal/Permeability Increasing Protein (BPI), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Bactericidal/Permeability Increasing Protein (BPI) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPB234Mu01 Recombinant Bactericidal/Permeability Increasing Protein (BPI) Positive Control; Immunogen; SDS-PAGE; WB.
RPB234Mu02 Recombinant Bactericidal/Permeability Increasing Protein (BPI) Positive Control; Immunogen; SDS-PAGE; WB.
PAB234Mu02 Polyclonal Antibody to Bactericidal/Permeability Increasing Protein (BPI) WB; IHC; ICC; IP.
PAB234Mu01 Polyclonal Antibody to Bactericidal/Permeability Increasing Protein (BPI) WB; IHC; ICC; IP.
SEB234Mu ELISA Kit for Bactericidal/Permeability Increasing Protein (BPI) Enzyme-linked immunosorbent assay for Antigen Detection.
LMB234Mu Multiplex Assay Kit for Bactericidal/Permeability Increasing Protein (BPI) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK