Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

Keratinocyte growth factor 2

  • Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10) Packages (Simulation)
  • Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10) Packages (Simulation)
  • Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10) Results demonstration
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

This assay has high sensitivity and excellent specificity for detection of Mini Samples Fibroblast Growth Factor 10 (FGF10).
No significant cross-reactivity or interference between Mini Samples Fibroblast Growth Factor 10 (FGF10) and analogues was observed.

Recovery of the Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

Matrices listed below were spiked with certain level of recombinant Mini Samples Fibroblast Growth Factor 10 (FGF10) and the recovery rates were calculated by comparing the measured value to the expected amount of Mini Samples Fibroblast Growth Factor 10 (FGF10) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 86-97 89
EDTA plasma(n=5) 98-105 102
heparin plasma(n=5) 85-92 88

Precision of the Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Mini Samples Fibroblast Growth Factor 10 (FGF10) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Mini Samples Fibroblast Growth Factor 10 (FGF10) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Mini Samples Fibroblast Growth Factor 10 (FGF10) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 82-94% 95-103% 84-103% 80-91%
EDTA plasma(n=5) 93-101% 92-101% 87-98% 80-93%
heparin plasma(n=5) 80-89% 89-97% 87-99% 92-101%

Stability of the Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Mini Samples Fibroblast Growth Factor 10 (FGF10). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Mini Samples Fibroblast Growth Factor 10 (FGF10). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Mini Samples Fibroblast Growth Factor 10 (FGF10), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Mini Samples Fibroblast Growth Factor 10 (FGF10) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPB882Mu02 Recombinant Fibroblast Growth Factor 10 (FGF10) Positive Control; Immunogen; SDS-PAGE; WB.
RPB882Mu01 Recombinant Fibroblast Growth Factor 10 (FGF10) Positive Control; Immunogen; SDS-PAGE; WB.
PAB882Mu02 Polyclonal Antibody to Fibroblast Growth Factor 10 (FGF10) WB; IHC; ICC; IP.
PAB882Mu01 Polyclonal Antibody to Fibroblast Growth Factor 10 (FGF10) WB; IHC; ICC; IP.
SEB882Mu ELISA Kit for Fibroblast Growth Factor 10 (FGF10) Enzyme-linked immunosorbent assay for Antigen Detection.
MEB882Mu Mini Samples ELISA Kit for Fibroblast Growth Factor 10 (FGF10) Enzyme-linked immunosorbent assay for Antigen Detection.
SCB882Mu CLIA Kit for Fibroblast Growth Factor 10 (FGF10) Chemiluminescent immunoassay for Antigen Detection.
LMB882Mu Multiplex Assay Kit for Fibroblast Growth Factor 10 (FGF10) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK