ELISA Kit for Vitamin B7 (VB7)

Biotin; Vitamin H; Coenzyme R; Biopeiderm

    • ELISA Kit for Vitamin B7 (VB7)Packages (Simulation)
    • ELISA Kit for Vitamin B7 (VB7)Packages (Simulation)
    • ELISA Kit for Vitamin B7 (VB7)Results demonstration
    • CEG162Ge.jpgTypical Standard Curve
    • CertificateISO9001: 2008, ISO13485: 2003 Registered


    This assay has high sensitivity and excellent specificity for detection of Vitamin B7 (VB7).
    No significant cross-reactivity or interference between Vitamin B7 (VB7) and analogues was observed.


    Matrices listed below were spiked with certain level of recombinant Vitamin B7 (VB7) and the recovery rates were calculated by comparing the measured value to the expected amount of Vitamin B7 (VB7) in samples.

    MatrixRecovery range (%)Average(%)
    EDTA plasma(n=5)85-10290
    heparin plasma(n=5)80-10580


    Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Vitamin B7 (VB7) were tested 20 times on one plate, respectively.
    Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Vitamin B7 (VB7) were tested on 3 different plates, 8 replicates in each plate.
    CV(%) = SD/meanX100
    Intra-Assay: CV<10%
    Inter-Assay: CV<12%


    The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Vitamin B7 (VB7) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

    EDTA plasma(n=5)81-101%86-93%93-101%85-103%
    heparin plasma(n=5)78-104%91-105%87-94%94-102%


    The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
    To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

    Reagents and materials provided

    Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
    Standard2Standard Diluent1×20mL
    Detection Reagent A1×120µLAssay Diluent A1×12mL
    Detection Reagent B1×120µLAssay Diluent B1×12mL
    TMB Substrate1×9mLStop Solution1×6mL
    Wash Buffer (30 × concentrate)1×20mLInstruction manual1

    Assay procedure summary

    1. Prepare all reagents, samples and standards;
    2. Add 50µL standard or sample to each well.
        And then add 50µL prepared Detection Reagent A immediately.
        Shake and mix. Incubate 1 hour at 37°C;
    3. Aspirate and wash 3 times;
    4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
    5. Aspirate and wash 5 times;
    6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
    7. Add 50µL Stop Solution. Read at 450 nm immediately.

    ELISA Kit for Vitamin B7 (VB7)

    Test principle

    This assay employs the competitive inhibition enzyme immunoassay technique. A monoclonal antibody specific to Vitamin B7 (VB7) has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled Vitamin B7 (VB7) and unlabeled Vitamin B7 (VB7) (Standards or samples) with the pre-coated antibody specific to Vitamin B7 (VB7). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Vitamin B7 (VB7) in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of Vitamin B7 (VB7) in the sample.

    Related products

    Catalog No.Organism species: Pan-species (General)Applications
    CEG162GeELISA Kit for Vitamin B7 (VB7)Enzyme-linked immunosorbent assay for Antigen Detection.