ELISA Kit for Beta-Thromboglobulin (bTG)

CXCL7; PPBP; PBP; B-TG1; CTAP-III; CTAP3; CTAPIII; LA-PF4; LDGF; MDGF; NAP2; SCYB7; TC1; TC2; TGB1; THBGB1; Pro-Platelet Basic Protein; Chemokine C-X-C-Motif Ligand 7

  • ELISA Kit for Beta-Thromboglobulin (bTG)Packages (Simulation)
  • ELISA Kit for Beta-Thromboglobulin (bTG)Packages (Simulation)
  • ELISA Kit for Beta-Thromboglobulin (bTG)Results demonstration
  • SEA370Ra.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered


This assay has high sensitivity and excellent specificity for detection of Beta-Thromboglobulin (bTG).
No significant cross-reactivity or interference between Beta-Thromboglobulin (bTG) and analogues was observed.


Matrices listed below were spiked with certain level of recombinant Beta-Thromboglobulin (bTG) and the recovery rates were calculated by comparing the measured value to the expected amount of Beta-Thromboglobulin (bTG) in samples.

MatrixRecovery range (%)Average(%)
EDTA plasma(n=5)95-10598
heparin plasma(n=5)78-10585


Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Beta-Thromboglobulin (bTG) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Beta-Thromboglobulin (bTG) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%


The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Beta-Thromboglobulin (bTG) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

EDTA plasma(n=5)84-93%93-101%83-95%83-91%
heparin plasma(n=5)83-101%85-93%96-103%78-94%


The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

ELISA Kit for Beta-Thromboglobulin (bTG)

Test principle

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Beta-Thromboglobulin (bTG). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Beta-Thromboglobulin (bTG). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Beta-Thromboglobulin (bTG), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Beta-Thromboglobulin (bTG) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No.Organism species: Rattus norvegicus (Rat)Applications
APA370Ra01Active Beta-Thromboglobulin (bTG)Cell culture; Activity Assays.
RPA370Ra02Recombinant Beta-Thromboglobulin (bTG)Positive Control; Immunogen; SDS-PAGE; WB.
RPA370Ra01Recombinant Beta-Thromboglobulin (bTG)Positive Control; Immunogen; SDS-PAGE; WB.
PAA370Ra01Polyclonal Antibody to Beta-Thromboglobulin (bTG)WB; IHC; ICC; IP.
PAA370Ra02Polyclonal Antibody to Beta-Thromboglobulin (bTG)WB; IHC; ICC; IP.
LAA370Ra81FITC-Linked Polyclonal Antibody to Beta-Thromboglobulin (bTG)WB; IHC; ICC; IF.
LAA370Ra71Biotin-Linked Polyclonal Antibody to Beta-Thromboglobulin (bTG)WB; IHC; ICC.
MAA370Ra22Monoclonal Antibody to Beta-Thromboglobulin (bTG)WB; IHC; ICC; IP.
SEA370RaELISA Kit for Beta-Thromboglobulin (bTG)Enzyme-linked immunosorbent assay for Antigen Detection.
SCA370RaCLIA Kit for Beta-Thromboglobulin (bTG)Chemiluminescent immunoassay for Antigen Detection.
KSA370Ra01ELISA Kit DIY Materials for Beta-Thromboglobulin (bTG)Main materials for "Do It (ELISA Kit) Yourself".