ELISA Kit for Osteopontin (OPN)
SPP1; BNSP; BSPI; ETA1; Secreted Phosphoprotein 1; Bone Sialoprotein I; Early T-Lymphocyte Activation 1; Nephropontin; Urinary stone protein; Uropontin
- Product No.SEA899Mu
- Organism SpeciesMus musculus (Mouse)Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range39-2,500pg/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 15pg/mL.
- Sample Typeserum, plasma, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
- DownloadInstruction Manual
- FOBUS$ 349
For more details, please contact local distributors!US$ 498
For more details, please contact local distributors!US$ 2241
For more details, please contact local distributors!US$ 4233
For more details, please contact local distributors!US$ 34860
For more details, please contact local distributors!
- Packages (Simulation)
- Packages (Simulation)
- Results demonstration
- Typical Standard Curve
- ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Osteopontin (OPN)
This assay has high sensitivity and excellent specificity for detection of Osteopontin (OPN).
No significant cross-reactivity or interference between Osteopontin (OPN) and analogues was observed.
Recovery of the ELISA Kit for Osteopontin (OPN)
Matrices listed below were spiked with certain level of recombinantOsteopontin (OPN) and the recovery rates were calculated by comparing the measured value to the expected amount of Osteopontin (OPN) in samples.
|Matrix||Recovery range (%)||Average(%)|
Precision of the ELISA Kit for Osteopontin (OPN)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Osteopontin (OPN) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Osteopontin (OPN) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Linearity of the ELISA Kit for Osteopontin (OPN)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Osteopontin (OPN) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
Stability of the ELISA Kit for Osteopontin (OPN)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Osteopontin (OPN)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Osteopontin (OPN)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Osteopontin (OPN). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Osteopontin (OPN). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Osteopontin (OPN), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Osteopontin (OPN) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
|Catalog No.||Organism species: Mus musculus (Mouse)||Applications (RESEARCH USE ONLY!)|
|RPA899Mu01||Recombinant Osteopontin (OPN)||Positive Control; Immunogen; SDS-PAGE; WB.|
|EPA899Mu61||Eukaryotic Osteopontin (OPN)||Positive Control; Immunogen; SDS-PAGE; WB.|
|RPA899Mu02||Recombinant Osteopontin (OPN)||Positive Control; Immunogen; SDS-PAGE; WB.|
|PAA899Mu01||Polyclonal Antibody to Osteopontin (OPN)||WB; IHC; ICC; IP.|
|PAA899Mu02||Polyclonal Antibody to Osteopontin (OPN)||WB; IHC; ICC; IP.|
|PAA899Mu06||Polyclonal Antibody to Osteopontin (OPN)||WB; IHC; ICC; IP.|
|SEA899Mu||ELISA Kit for Osteopontin (OPN)||Enzyme-linked immunosorbent assay for Antigen Detection.|
|SCA899Mu||CLIA Kit for Osteopontin (OPN)||Chemiluminescent immunoassay for Antigen Detection.|
|KSA899Mu01||ELISA Kit DIY Materials for Osteopontin (OPN)||Main materials for "Do It (ELISA Kit) Yourself".|