ELISA Kit for Interleukin 1 Receptor Antagonist (IL1RA)

IL1RN; IL1-RA; ICIL1RA; IL1ra3; IL1F3; IRAP;IL-1RA; Interleukin-1 Family Member 3; IL1 inhibitor; Anakinra

FOR IN VITRO AND RESEARCH USE ONLY, NOT FOR USE IN CLINICAL DIAGNOSTIC PROCEDURES!
  • ELISA Kit for Interleukin 1 Receptor Antagonist (IL1RA)Packages (Simulation)
  • ELISA Kit for Interleukin 1 Receptor Antagonist (IL1RA)Packages (Simulation)
  • ELISA Kit for Interleukin 1 Receptor Antagonist (IL1RA)Results demonstration
  • SEA223Mu.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity

This assay has high sensitivity and excellent specificity for detection of Interleukin 1 Receptor Antagonist (IL1RA).
No significant cross-reactivity or interference between Interleukin 1 Receptor Antagonist (IL1RA) and analogues was observed.

Recovery

Matrices listed below were spiked with certain level of recombinant Interleukin 1 Receptor Antagonist (IL1RA) and the recovery rates were calculated by comparing the measured value to the expected amount of Interleukin 1 Receptor Antagonist (IL1RA) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)79-9083
EDTA plasma(n=5)88-9692
heparin plasma(n=5)82-9589

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Interleukin 1 Receptor Antagonist (IL1RA) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Interleukin 1 Receptor Antagonist (IL1RA) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Interleukin 1 Receptor Antagonist (IL1RA) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)94-102%89-101%97-105%81-90%
EDTA plasma(n=5)97-105%83-97%80-96%94-105%
heparin plasma(n=5)94-102%97-104%80-99%78-94%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

ELISA Kit for Interleukin 1 Receptor Antagonist (IL1RA)

Test principle

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Interleukin 1 Receptor Antagonist (IL1RA). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Interleukin 1 Receptor Antagonist (IL1RA). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Interleukin 1 Receptor Antagonist (IL1RA), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Interleukin 1 Receptor Antagonist (IL1RA) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No.Organism species: Mus musculus (Mouse)Applications
APA223Mu01Active Interleukin 1 Receptor Antagonist (IL1RA)Cell culture; Activity Assays.
RPA223Mu02Recombinant Interleukin 1 Receptor Antagonist (IL1RA)Positive Control; Immunogen; SDS-PAGE; WB.
RPA223Mu01Recombinant Interleukin 1 Receptor Antagonist (IL1RA)Positive Control; Immunogen; SDS-PAGE; WB.
PAA223Mu02Polyclonal Antibody to Interleukin 1 Receptor Antagonist (IL1RA)WB; IHC; ICC; IP.
PAA223Mu01Polyclonal Antibody to Interleukin 1 Receptor Antagonist (IL1RA)WB; IHC; ICC; IP.
LAA223Mu71Biotin-Linked Polyclonal Antibody to Interleukin 1 Receptor Antagonist (IL1RA)WB; IHC; ICC.
LAA223Mu81FITC-Linked Polyclonal Antibody to Interleukin 1 Receptor Antagonist (IL1RA)WB; IHC; ICC; IF.
SEA223MuELISA Kit for Interleukin 1 Receptor Antagonist (IL1RA)Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK