ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

ADHR; HYPF; HPDR2; PHPTC; Phosphatonin; Tumor-derived hypophosphatemia-inducing factor

  • ELISA Kit for Fibroblast Growth Factor 23 (FGF23) Packages (Simulation)
  • ELISA Kit for Fibroblast Growth Factor 23 (FGF23) Packages (Simulation)
  • ELISA Kit for Fibroblast Growth Factor 23 (FGF23) Results demonstration
  • SEA746Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

This assay has high sensitivity and excellent specificity for detection of Fibroblast Growth Factor 23 (FGF23).
No significant cross-reactivity or interference between Fibroblast Growth Factor 23 (FGF23) and analogues was observed.

Recovery of the ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

Matrices listed below were spiked with certain level of recombinant Fibroblast Growth Factor 23 (FGF23) and the recovery rates were calculated by comparing the measured value to the expected amount of Fibroblast Growth Factor 23 (FGF23) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 87-105 93
EDTA plasma(n=5) 81-101 87
heparin plasma(n=5) 92-105 98

Precision of the ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Fibroblast Growth Factor 23 (FGF23) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Fibroblast Growth Factor 23 (FGF23) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Fibroblast Growth Factor 23 (FGF23) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 96-103% 94-102% 94-101% 78-91%
EDTA plasma(n=5) 82-102% 94-103% 95-103% 99-105%
heparin plasma(n=5) 91-99% 87-98% 78-99% 84-101%

Stability of the ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Fibroblast Growth Factor 23 (FGF23)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Fibroblast Growth Factor 23 (FGF23). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Fibroblast Growth Factor 23 (FGF23). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Fibroblast Growth Factor 23 (FGF23), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Fibroblast Growth Factor 23 (FGF23) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPA746Mu01 Recombinant Fibroblast Growth Factor 23 (FGF23) Positive Control; Immunogen; SDS-PAGE; WB.
RPA746Mu03 Recombinant Fibroblast Growth Factor 23 (FGF23) Positive Control; Immunogen; SDS-PAGE; WB.
APA746Mu03 Active Fibroblast Growth Factor 23 (FGF23) Cell culture; Activity Assays.
RPA746Mu02 Recombinant Fibroblast Growth Factor 23 (FGF23) Positive Control; Immunogen; SDS-PAGE; WB.
APA746Mu01 Active Fibroblast Growth Factor 23 (FGF23) Cell culture; Activity Assays.
PAA746Mu02 Polyclonal Antibody to Fibroblast Growth Factor 23 (FGF23) WB; IHC; ICC; IP.
PAA746Mu01 Polyclonal Antibody to Fibroblast Growth Factor 23 (FGF23) WB; IHC; ICC; IP.
MEA746Mu Mini Samples ELISA Kit for Fibroblast Growth Factor 23 (FGF23) Enzyme-linked immunosorbent assay for Antigen Detection.
SEA746Mu ELISA Kit for Fibroblast Growth Factor 23 (FGF23) Enzyme-linked immunosorbent assay for Antigen Detection.
LMA746Mu Multiplex Assay Kit for Fibroblast Growth Factor 23 (FGF23) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA746Mu01 ELISA Kit DIY Materials for Fibroblast Growth Factor 23 (FGF23) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK