ELISA Kit for Factor Related Apoptosis (FAS)

CD95; ALPS1A; ALPS1-A; APO1; APT1; FAS1; FASTM; TNFRSF6; Fas Receptor; TNF Receptor Superfamily Member 6; Tumor Necrosis Factor Receptor Superfamily Member 6

  • ELISA Kit for Factor Related Apoptosis (FAS)Packages (Simulation)
  • ELISA Kit for Factor Related Apoptosis (FAS)Packages (Simulation)
  • ELISA Kit for Factor Related Apoptosis (FAS)Results demonstration
  • SEA030Mu.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Factor Related Apoptosis (FAS)

This assay has high sensitivity and excellent specificity for detection of Factor Related Apoptosis (FAS).
No significant cross-reactivity or interference between Factor Related Apoptosis (FAS) and analogues was observed.

Recovery of the ELISA Kit for Factor Related Apoptosis (FAS)

Matrices listed below were spiked with certain level of recombinantFactor Related Apoptosis (FAS) and the recovery rates were calculated by comparing the measured value to the expected amount of Factor Related Apoptosis (FAS) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)79-10289
EDTA plasma(n=5)89-10196
heparin plasma(n=5)86-9590

Precision of the ELISA Kit for Factor Related Apoptosis (FAS)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Factor Related Apoptosis (FAS) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Factor Related Apoptosis (FAS) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Factor Related Apoptosis (FAS)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Factor Related Apoptosis (FAS) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)80-95%82-103%94-102%96-105%
EDTA plasma(n=5)78-91%86-101%78-103%85-98%
heparin plasma(n=5)92-99%99-105%87-97%84-93%

Stability of the ELISA Kit for Factor Related Apoptosis (FAS)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Factor Related Apoptosis (FAS)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Factor Related Apoptosis (FAS)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Factor Related Apoptosis (FAS). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Factor Related Apoptosis (FAS). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Factor Related Apoptosis (FAS), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Factor Related Apoptosis (FAS) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No.Organism species: Mus musculus (Mouse)Applications (RESEARCH USE ONLY!)
RPA030Mu01Recombinant Factor Related Apoptosis (FAS)Positive Control; Immunogen; SDS-PAGE; WB.
RPA030Mu02Recombinant Factor Related Apoptosis (FAS)Positive Control; Immunogen; SDS-PAGE; WB.
PAA030Mu02Polyclonal Antibody to Factor Related Apoptosis (FAS)WB; IHC; ICC; IP.
PAA030Mu01Polyclonal Antibody to Factor Related Apoptosis (FAS)WB; IHC; ICC; IP.
LAA030Mu71Biotin-Linked Polyclonal Antibody to Factor Related Apoptosis (FAS)WB; IHC; ICC.
SEA030MuELISA Kit for Factor Related Apoptosis (FAS)Enzyme-linked immunosorbent assay for Antigen Detection.
SCA030MuCLIA Kit for Factor Related Apoptosis (FAS)Chemiluminescent immunoassay for Antigen Detection.
KSA030Mu01ELISA Kit DIY Materials for Factor Related Apoptosis (FAS)Main materials for "Do It(ELISA Kit) Yourself"
GUESTBOOK