ELISA Kit for Lipocalin 1 (LCN1)
TP; PMFA; VEGP; Tlc; Tear Prealbumin; Tear lipocalin; Protein Migrating Faster Than Albumin; Von Ebner Gland Protein
- Product No.SEB706Hu
- Organism SpeciesHomo sapiens (Human)Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range0.78-50ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 0.30ng/mL.
- Sample Typeserum, plasma, saliva, tissue homogenates, cell lysates, tears, cell culture supernates and other biological fluids
- DownloadInstruction Manual
- FOBUS$ 466
For more details, please contact local distributors!US$ 665
For more details, please contact local distributors!US$ 2993
For more details, please contact local distributors!US$ 5653
For more details, please contact local distributors!US$ 46550
For more details, please contact local distributors!
- Packages (Simulation)
- Packages (Simulation)
- Results demonstration
- Typical Standard Curve
- ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Lipocalin 1 (LCN1)
This assay has high sensitivity and excellent specificity for detection of Lipocalin 1 (LCN1).
No significant cross-reactivity or interference between Lipocalin 1 (LCN1) and analogues was observed.
Recovery of the ELISA Kit for Lipocalin 1 (LCN1)
Matrices listed below were spiked with certain level of recombinantLipocalin 1 (LCN1) and the recovery rates were calculated by comparing the measured value to the expected amount of Lipocalin 1 (LCN1) in samples.
|Matrix||Recovery range (%)||Average(%)|
Precision of the ELISA Kit for Lipocalin 1 (LCN1)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Lipocalin 1 (LCN1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Lipocalin 1 (LCN1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Linearity of the ELISA Kit for Lipocalin 1 (LCN1)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Lipocalin 1 (LCN1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
Stability of the ELISA Kit for Lipocalin 1 (LCN1)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Reagents and materials provided of the ELISA Kit for Lipocalin 1 (LCN1)
|Pre-coated, ready to use 96-well strip plate||1||Plate sealer for 96 wells||4|
|Detection Reagent A||1×120µL||Assay Diluent A||1×12mL|
|Detection Reagent B||1×120µL||Assay Diluent B||1×12mL|
|TMB Substrate||1×9mL||Stop Solution||1×6mL|
|Wash Buffer (30 × concentrate)||1×20mL||Instruction manual||1|
Assay procedure summary of the ELISA Kit for Lipocalin 1 (LCN1)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Lipocalin 1 (LCN1)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Lipocalin 1 (LCN1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Lipocalin 1 (LCN1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Lipocalin 1 (LCN1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Lipocalin 1 (LCN1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
|Catalog No.||Organism species: Homo sapiens (Human)||Applications (RESEARCH USE ONLY!)|
|RPB706Hu01||Recombinant Lipocalin 1 (LCN1)||Positive Control; Immunogen; SDS-PAGE; WB.|
|PAB706Hu01||Polyclonal Antibody to Lipocalin 1 (LCN1)||WB; IHC; ICC; IP.|
|MAB706Hu22||Monoclonal Antibody to Lipocalin 1 (LCN1)||WB; IHC; ICC; IP.|
|SEB706Hu||ELISA Kit for Lipocalin 1 (LCN1)||Enzyme-linked immunosorbent assay for Antigen Detection.|
|KSB706Hu01||ELISA Kit DIY Materials for Lipocalin 1 (LCN1)||Main materials for "Do It (ELISA Kit) Yourself".|