ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

CLEC4H1; HL-1; ASGPR 1; Asialoglyco protein Receptor; C-type lectin domain family 4 member H1; Hepatic lectin H1

  • ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)Packages (Simulation)
  • ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)Packages (Simulation)
  • ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)Results demonstration
  • SEB189Hu.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

This assay has high sensitivity and excellent specificity for detection of Asialoglycoprotein Receptor 1 (ASGR1).
No significant cross-reactivity or interference between Asialoglycoprotein Receptor 1 (ASGR1) and analogues was observed.

Recovery of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

Matrices listed below were spiked with certain level of recombinantAsialoglycoprotein Receptor 1 (ASGR1) and the recovery rates were calculated by comparing the measured value to the expected amount of Asialoglycoprotein Receptor 1 (ASGR1) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)83-10289
EDTA plasma(n=5)89-9894
heparin plasma(n=5)88-10193

Precision of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Asialoglycoprotein Receptor 1 (ASGR1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Asialoglycoprotein Receptor 1 (ASGR1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Asialoglycoprotein Receptor 1 (ASGR1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)97-105%85-94%88-95%80-98%
EDTA plasma(n=5)91-98%99-105%89-103%79-95%
heparin plasma(n=5)78-90%81-101%94-101%84-91%

Stability of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

Test principle of the ELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Asialoglycoprotein Receptor 1 (ASGR1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Asialoglycoprotein Receptor 1 (ASGR1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Asialoglycoprotein Receptor 1 (ASGR1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Asialoglycoprotein Receptor 1 (ASGR1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No.Organism species: Homo sapiens (Human)Applications (RESEARCH USE ONLY!)
RPB189Hu01Recombinant Asialoglycoprotein Receptor 1 (ASGR1)Positive Control; Immunogen; SDS-PAGE; WB.
PAB189Hu01Polyclonal Antibody to Asialoglycoprotein Receptor 1 (ASGR1)WB; IHC; ICC; IP.
MAB189Hu22Monoclonal Antibody to Asialoglycoprotein Receptor 1 (ASGR1)WB; IHC; ICC; IP.
SEB189HuELISA Kit for Asialoglycoprotein Receptor 1 (ASGR1)Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK