ELISA Kit for Fibrinopeptide B (FPB)

FP-B

  • ELISA Kit for Fibrinopeptide B (FPB)Packages (Simulation)
  • ELISA Kit for Fibrinopeptide B (FPB)Packages (Simulation)
  • ELISA Kit for Fibrinopeptide B (FPB)Results demonstration
  • CEB307Hu.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Fibrinopeptide B (FPB)

This assay has high sensitivity and excellent specificity for detection of Fibrinopeptide B (FPB).
No significant cross-reactivity or interference between Fibrinopeptide B (FPB) and analogues was observed.

Recovery of the ELISA Kit for Fibrinopeptide B (FPB)

Matrices listed below were spiked with certain level of recombinantFibrinopeptide B (FPB) and the recovery rates were calculated by comparing the measured value to the expected amount of Fibrinopeptide B (FPB) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)98-105101
EDTA plasma(n=5)89-9995
heparin plasma(n=5)99-105102

Precision of the ELISA Kit for Fibrinopeptide B (FPB)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Fibrinopeptide B (FPB) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Fibrinopeptide B (FPB) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Fibrinopeptide B (FPB)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Fibrinopeptide B (FPB) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)96-105%79-105%92-101%88-99%
EDTA plasma(n=5)84-105%94-103%79-99%78-97%
heparin plasma(n=5)85-97%80-99%80-94%89-103%

Stability of the ELISA Kit for Fibrinopeptide B (FPB)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided of the ELISA Kit for Fibrinopeptide B (FPB)

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1Assay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
Reagent Diluent1×300µLStop Solution1×6mL
TMB Substrate1×9mLInstruction manual1
Wash Buffer (30 × concentrate)1×20mL

Assay procedure summary of the ELISA Kit for Fibrinopeptide B (FPB)

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
7. Add 50µL Stop Solution. Read at 450 nm immediately.

ELISA Kit for Fibrinopeptide B (FPB)

Test principle of the ELISA Kit for Fibrinopeptide B (FPB)

This assay employs the competitive inhibition enzyme immunoassay technique. A monoclonal antibody specific to Fibrinopeptide B (FPB) has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled Fibrinopeptide B (FPB) and unlabeled Fibrinopeptide B (FPB) (Standards or samples) with the pre-coated antibody specific to Fibrinopeptide B (FPB). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Fibrinopeptide B (FPB) in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of Fibrinopeptide B (FPB) in the sample.

Related products

Catalog No.Organism species: Homo sapiens (Human)Applications (RESEARCH USE ONLY!)
CPB307Hu31KLH Conjugated Fibrinopeptide B (FPB)Immunogen; SDS-PAGE; WB.
PAB307Hu08Polyclonal Antibody to Fibrinopeptide B (FPB)WB; IHC; ICC; IP.
CEB307HuELISA Kit for Fibrinopeptide B (FPB)Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK