ELISA Kit for Desmoglein 3 (DSG3)

CDHF6; PVA; 130 kDa pemphigus vulgaris antigen; Cadherin family member 6

FOR IN VITRO AND RESEARCH USE ONLY, NOT FOR USE IN CLINICAL DIAGNOSTIC PROCEDURES!
  • ELISA Kit for Desmoglein 3 (DSG3)Packages (Simulation)
  • ELISA Kit for Desmoglein 3 (DSG3)Packages (Simulation)
  • ELISA Kit for Desmoglein 3 (DSG3)Results demonstration
  • SEA444Hu.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity

This assay has high sensitivity and excellent specificity for detection of Desmoglein 3 (DSG3).
No significant cross-reactivity or interference between Desmoglein 3 (DSG3) and analogues was observed.

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Desmoglein 3 (DSG3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Desmoglein 3 (DSG3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

ELISA Kit for Desmoglein 3 (DSG3)

Test principle

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Desmoglein 3 (DSG3). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Desmoglein 3 (DSG3). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Desmoglein 3 (DSG3), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Desmoglein 3 (DSG3) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No.Organism species: Homo sapiens (Human)Applications
RPA444Hu01Recombinant Desmoglein 3 (DSG3)Positive Control; Immunogen; SDS-PAGE; WB.
PAA444Hu01Polyclonal Antibody to Desmoglein 3 (DSG3)WB; ICC; IHC-P; IHC-F; ELISA.
MAA444Hu22Monoclonal Antibody to Desmoglein 3 (DSG3)WB; IHC; ICC; IP.
SEA444HuELISA Kit for Desmoglein 3 (DSG3)Enzyme-linked immunosorbent assay for Antigen Detection.
KSA444Hu01ELISA Kit DIY Materials for Desmoglein 3 (DSG3)Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK