CLIA Kit for Semaphorin 3A (SEMA3A)

SEMAL; Hsema-I; Hsema-III; SEMA1; SEMAD; SEMAIII; SemD; Coll-1; Sema Domain,Immunoglobulin Domain(Ig),Transmembrane Domain(TM)and Short Cytoplasmic Domain 3A

  • CLIA Kit for Semaphorin 3A (SEMA3A) Packages (Simulation)
  • CLIA Kit for Semaphorin 3A (SEMA3A) Packages (Simulation)
  • CLIA Kit for Semaphorin 3A (SEMA3A) Results demonstration
  • SCL917Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Semaphorin 3A (SEMA3A)

This assay has high sensitivity and excellent specificity for detection of Semaphorin 3A (SEMA3A).
No significant cross-reactivity or interference between Semaphorin 3A (SEMA3A) and analogues was observed.

Recovery of the CLIA Kit for Semaphorin 3A (SEMA3A)

Matrices listed below were spiked with certain level of recombinant Semaphorin 3A (SEMA3A) and the recovery rates were calculated by comparing the measured value to the expected amount of Semaphorin 3A (SEMA3A) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 85-93 88
EDTA plasma(n=5) 80-96 87
heparin plasma(n=5) 80-93 84

Precision of the CLIA Kit for Semaphorin 3A (SEMA3A)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Semaphorin 3A (SEMA3A) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Semaphorin 3A (SEMA3A) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Semaphorin 3A (SEMA3A)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Semaphorin 3A (SEMA3A) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 83-95% 78-103% 93-101% 79-94%
EDTA plasma(n=5) 97-104% 95-105% 86-98% 91-98%
heparin plasma(n=5) 81-101% 94-102% 99-105% 96-105%

Stability of the CLIA Kit for Semaphorin 3A (SEMA3A)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Semaphorin 3A (SEMA3A)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Semaphorin 3A (SEMA3A)

The microplate provided in this kit has been pre-coated with an antibody specific to Semaphorin 3A (SEMA3A). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Semaphorin 3A (SEMA3A). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Semaphorin 3A (SEMA3A) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
APL917Hu02 Active Semaphorin 3A (SEMA3A) Cell culture; Activity Assays.
APL917Hu01 Active Semaphorin 3A (SEMA3A) Cell culture; Activity Assays.
RPL917Hu01 Recombinant Semaphorin 3A (SEMA3A) Positive Control; Immunogen; SDS-PAGE; WB.
RPL917Hu02 Recombinant Semaphorin 3A (SEMA3A) Positive Control; Immunogen; SDS-PAGE; WB.
PAL917Hu01 Polyclonal Antibody to Semaphorin 3A (SEMA3A) WB; IHC; ICC; IP.
PAL917Hu02 Polyclonal Antibody to Semaphorin 3A (SEMA3A) WB; IHC; ICC; IP.
LAL917Hu71 Biotin-Linked Polyclonal Antibody to Semaphorin 3A (SEMA3A) WB; IHC; ICC.
MAL917Hu22 Monoclonal Antibody to Semaphorin 3A (SEMA3A) WB; IHC; ICC; IP.
MAL917Hu23 Monoclonal Antibody to Semaphorin 3A (SEMA3A) WB; IHC; ICC; IP.
MAL917Hu24 Monoclonal Antibody to Semaphorin 3A (SEMA3A) WB; IHC; ICC; IP.
MAL917Hu21 Monoclonal Antibody to Semaphorin 3A (SEMA3A) WB,IHC
LAL917Hu72 Biotin-Linked Monoclonal Antibody to Semaphorin 3A (SEMA3A) WB; IHC; ICC.
SEL917Hu ELISA Kit for Semaphorin 3A (SEMA3A) Enzyme-linked immunosorbent assay for Antigen Detection.
SCL917Hu CLIA Kit for Semaphorin 3A (SEMA3A) Chemiluminescent immunoassay for Antigen Detection.
LML917Hu Multiplex Assay Kit for Semaphorin 3A (SEMA3A) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK