CLIA Kit for Myostatin (MSTN)

GDF8; Growth Differentiation Factor 8

  • CLIA Kit for Myostatin (MSTN) Packages (Simulation)
  • CLIA Kit for Myostatin (MSTN) Packages (Simulation)
  • CLIA Kit for Myostatin (MSTN) Results demonstration
  • SCB653Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Myostatin (MSTN)

This assay has high sensitivity and excellent specificity for detection of Myostatin (MSTN).
No significant cross-reactivity or interference between Myostatin (MSTN) and analogues was observed.

Recovery of the CLIA Kit for Myostatin (MSTN)

Matrices listed below were spiked with certain level of recombinant Myostatin (MSTN) and the recovery rates were calculated by comparing the measured value to the expected amount of Myostatin (MSTN) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 93-101 97
EDTA plasma(n=5) 79-101 93
heparin plasma(n=5) 87-102 98

Precision of the CLIA Kit for Myostatin (MSTN)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Myostatin (MSTN) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Myostatin (MSTN) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Myostatin (MSTN)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Myostatin (MSTN) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 80-88% 88-95% 91-101% 85-105%
EDTA plasma(n=5) 92-99% 88-96% 79-97% 97-105%
heparin plasma(n=5) 97-104% 78-96% 81-97% 95-105%

Stability of the CLIA Kit for Myostatin (MSTN)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Myostatin (MSTN)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Myostatin (MSTN)

The microplate provided in this kit has been pre-coated with an antibody specific to Myostatin (MSTN). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Myostatin (MSTN). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Myostatin (MSTN) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
APB653Hu01 Active Myostatin (MSTN) Cell culture; Activity Assays.
EPB653Hu61 Eukaryotic Myostatin (MSTN) Positive Control; Immunogen; SDS-PAGE; WB.
RPB653Hu01 Recombinant Myostatin (MSTN) Positive Control; Immunogen; SDS-PAGE; WB.
APB653Hu61 Active Myostatin (MSTN) Cell culture; Activity Assays.
CPB653Hu21 OVA Conjugated Myostatin (MSTN) Immunogen; SDS-PAGE; WB.
PAB653Hu08 Polyclonal Antibody to Myostatin (MSTN) WB; IHC; ICC; IP.
PAB653Hu06 Polyclonal Antibody to Myostatin (MSTN) WB; IHC; ICC; IP.
PAB653Hu01 Polyclonal Antibody to Myostatin (MSTN) WB; IHC; ICC; IP.
LAB653Hu71 Biotin-Linked Polyclonal Antibody to Myostatin (MSTN) WB; IHC; ICC.
MAB653Hu22 Monoclonal Antibody to Myostatin (MSTN) WB; IHC; ICC; IP.
MAB653Hu21 Monoclonal Antibody to Myostatin (MSTN) WB; IHC; ICC; IP.
SEB653Hu ELISA Kit for Myostatin (MSTN) Enzyme-linked immunosorbent assay for Antigen Detection.
CEB653Hu ELISA Kit for Myostatin (MSTN) Enzyme-linked immunosorbent assay for Antigen Detection.
SCB653Hu CLIA Kit for Myostatin (MSTN) Chemiluminescent immunoassay for Antigen Detection.
LMB653Hu Multiplex Assay Kit for Myostatin (MSTN) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSB653Hu11 ELISA Kit DIY Materials for Myostatin (MSTN) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK