CLIA Kit for Myoglobin (MYO)

PVALB; MB

  • CLIA Kit for Myoglobin (MYO)Packages (Simulation)
  • CLIA Kit for Myoglobin (MYO)Packages (Simulation)
  • CLIA Kit for Myoglobin (MYO)Results demonstration
  • SCA480Mu.jpgTypical Standard Curve
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Myoglobin (MYO)

This assay has high sensitivity and excellent specificity for detection of Myoglobin (MYO).
No significant cross-reactivity or interference between Myoglobin (MYO) and analogues was observed.

Recovery of the CLIA Kit for Myoglobin (MYO)

Matrices listed below were spiked with certain level of recombinantMyoglobin (MYO) and the recovery rates were calculated by comparing the measured value to the expected amount of Myoglobin (MYO) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)87-9490
EDTA plasma(n=5)86-9789
heparin plasma(n=5)89-10294

Precision of the CLIA Kit for Myoglobin (MYO)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Myoglobin (MYO) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Myoglobin (MYO) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Myoglobin (MYO)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Myoglobin (MYO) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)78-89%93-105%79-102%87-101%
EDTA plasma(n=5)79-91%95-102%92-99%94-102%
heparin plasma(n=5)96-103%89-96%78-102%83-98%

Stability of the CLIA Kit for Myoglobin (MYO)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided of the CLIA Kit for Myoglobin (MYO)

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
Substrate A1×10mLSubstrate B1×2mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary of the CLIA Kit for Myoglobin (MYO)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

CLIA Kit for Myoglobin (MYO)

Test principle of the CLIA Kit for Myoglobin (MYO)

The microplate provided in this kit has been pre-coated with an antibody specific to Myoglobin (MYO). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Myoglobin (MYO). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Myoglobin (MYO) level in the sample or standard.;

Related products

Catalog No.Organism species: Mus musculus (Mouse)Applications (RESEARCH USE ONLY!)
RPA480Mu02Recombinant Myoglobin (MYO)Positive Control; Immunogen; SDS-PAGE; WB.
RPA480Mu01Recombinant Myoglobin (MYO)Positive Control; Immunogen; SDS-PAGE; WB.
PAA480Mu02Polyclonal Antibody to Myoglobin (MYO)WB; IHC; ICC; IP.
PAA480Mu01Polyclonal Antibody to Myoglobin (MYO)WB; IHC; ICC; IP.
LAA480Mu81FITC-Linked Polyclonal Antibody to Myoglobin (MYO)WB; IHC; ICC; IF.
LAA480Mu71Biotin-Linked Polyclonal Antibody to Myoglobin (MYO)WB; IHC; ICC.
SEA480MuELISA Kit for Myoglobin (MYO)Enzyme-linked immunosorbent assay for Antigen Detection.
SCA480MuCLIA Kit for Myoglobin (MYO)Chemiluminescent immunoassay for Antigen Detection.
GUESTBOOK