CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

CLC; NR6; BSF3; CISS2; NNT1; Novel Neurotrophin-1; B Cell-Stimulating Factor-3

  • CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)Packages (Simulation)
  • CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)Packages (Simulation)
  • CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)Results demonstration
  • CertificateISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

This assay has high sensitivity and excellent specificity for detection of Cardiotrophin Like Cytokine Factor 1 (CLCF1).
No significant cross-reactivity or interference between Cardiotrophin Like Cytokine Factor 1 (CLCF1) and analogues was observed.

Recovery of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

Matrices listed below were spiked with certain level of recombinantCardiotrophin Like Cytokine Factor 1 (CLCF1) and the recovery rates were calculated by comparing the measured value to the expected amount of Cardiotrophin Like Cytokine Factor 1 (CLCF1) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)87-10392
EDTA plasma(n=5)99-105102
heparin plasma(n=5)80-9686

Precision of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Cardiotrophin Like Cytokine Factor 1 (CLCF1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Cardiotrophin Like Cytokine Factor 1 (CLCF1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Cardiotrophin Like Cytokine Factor 1 (CLCF1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)91-101%94-105%86-94%93-101%
EDTA plasma(n=5)83-97%86-93%92-99%82-96%
heparin plasma(n=5)79-92%84-93%81-101%79-101%

Stability of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
Substrate A1×10mLSubstrate B1×2mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

Test principle of the CLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)

The microplate provided in this kit has been pre-coated with an antibody specific to Cardiotrophin Like Cytokine Factor 1 (CLCF1). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Cardiotrophin Like Cytokine Factor 1 (CLCF1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Cardiotrophin Like Cytokine Factor 1 (CLCF1) level in the sample or standard.;

Related products

Catalog No.Organism species: Mus musculus (Mouse)Applications (RESEARCH USE ONLY!)
RPC389Mu02Recombinant Cardiotrophin Like Cytokine Factor 1 (CLCF1)Positive Control; Immunogen; SDS-PAGE; WB.
RPC389Mu01Recombinant Cardiotrophin Like Cytokine Factor 1 (CLCF1)Positive Control; Immunogen; SDS-PAGE; WB.
PAC389Mu02Polyclonal Antibody to Cardiotrophin Like Cytokine Factor 1 (CLCF1)WB; IHC; ICC; IP.
PAC389Mu01Polyclonal Antibody to Cardiotrophin Like Cytokine Factor 1 (CLCF1)WB; IHC; ICC; IP.
SEC389MuELISA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)Enzyme-linked immunosorbent assay for Antigen Detection.
SCC389MuCLIA Kit for Cardiotrophin Like Cytokine Factor 1 (CLCF1)Chemiluminescent immunoassay for Antigen Detection.
GUESTBOOK