CLIA Kit for Aprotinin (AP)

BPTI; Trasylol; Pancreatic Trypsin Inhibitor; Basic protease inhibitor

  • CLIA Kit for Aprotinin (AP) Packages (Simulation)
  • CLIA Kit for Aprotinin (AP) Packages (Simulation)
  • CLIA Kit for Aprotinin (AP) Results demonstration
  • CCA968Bo.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Aprotinin (AP)

This assay has high sensitivity and excellent specificity for detection of Aprotinin (AP).
No significant cross-reactivity or interference between Aprotinin (AP) and analogues was observed.

Recovery of the CLIA Kit for Aprotinin (AP)

Matrices listed below were spiked with certain level of recombinant Aprotinin (AP) and the recovery rates were calculated by comparing the measured value to the expected amount of Aprotinin (AP) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 87-94 91
EDTA plasma(n=5) 78-96 85
heparin plasma(n=5) 79-96 78

Precision of the CLIA Kit for Aprotinin (AP)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Aprotinin (AP) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Aprotinin (AP) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Aprotinin (AP)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Aprotinin (AP) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 84-92% 95-103% 90-98% 81-89%
EDTA plasma(n=5) 90-101% 86-102% 93-101% 99-105%
heparin plasma(n=5) 89-101% 94-102% 87-103% 85-97%

Stability of the CLIA Kit for Aprotinin (AP)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Aprotinin (AP)

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
7. Read RLU value immediately.

Test principle of the CLIA Kit for Aprotinin (AP)

The microplate provided in this kit has been pre-coated with a monoclonal antibody specific to Aprotinin (AP). A competitive inhibition reaction is launched between biotin labeled Aprotinin (AP) and unlabeled Aprotinin (AP) (Standards or samples) with the pre-coated antibody specific to Aprotinin (AP). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Aprotinin (AP) in the sample. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is reverse proportional to the Aprotinin (AP) level in the sample or standard.

Related products

Catalog No. Organism species: Bos taurus; Bovine (Cattle) Applications (RESEARCH USE ONLY!)
NPA968Bo01 Native Aprotinin (AP) Positive Control; Immunogen; SDS-PAGE; WB.
APA968Bo61 Active Aprotinin (AP) Cell culture; Activity Assays.
EPA968Bo61 Eukaryotic Aprotinin (AP) Positive Control; Immunogen; SDS-PAGE; WB.
APA968Bo01 Active Aprotinin (AP) Cell culture; Activity Assays.
RPA968Bo01 Recombinant Aprotinin (AP) Positive Control; Immunogen; SDS-PAGE; WB.
PAA968Bo01 Polyclonal Antibody to Aprotinin (AP) WB; IHC; ICC; IP.
LAA968Bo71 Biotin-Linked Polyclonal Antibody to Aprotinin (AP) WB; IHC; ICC.
MAA968Bo21 Monoclonal Antibody to Aprotinin (AP) WB; IHC; ICC; IP.
CEA968Bo ELISA Kit for Aprotinin (AP) Enzyme-linked immunosorbent assay for Antigen Detection.
CCA968Bo CLIA Kit for Aprotinin (AP) Chemiluminescent immunoassay for Antigen Detection.
LMA968Bo Multiplex Assay Kit for Aprotinin (AP) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA968Bo11 ELISA Kit DIY Materials for Aprotinin (AP) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK