CLIA Kit for Angiopoietin 1 (ANGPT1)

ANG1; AGP1; AGPT; ANG-I

  • CLIA Kit for Angiopoietin 1 (ANGPT1) Packages (Simulation)
  • CLIA Kit for Angiopoietin 1 (ANGPT1) Packages (Simulation)
  • CLIA Kit for Angiopoietin 1 (ANGPT1) Results demonstration
  • SCA008Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Angiopoietin 1 (ANGPT1)

This assay has high sensitivity and excellent specificity for detection of Angiopoietin 1 (ANGPT1).
No significant cross-reactivity or interference between Angiopoietin 1 (ANGPT1) and analogues was observed.

Recovery of the CLIA Kit for Angiopoietin 1 (ANGPT1)

Matrices listed below were spiked with certain level of recombinant Angiopoietin 1 (ANGPT1) and the recovery rates were calculated by comparing the measured value to the expected amount of Angiopoietin 1 (ANGPT1) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 79-90 83
EDTA plasma(n=5) 92-105 101
heparin plasma(n=5) 99-105 102

Precision of the CLIA Kit for Angiopoietin 1 (ANGPT1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Angiopoietin 1 (ANGPT1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Angiopoietin 1 (ANGPT1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Angiopoietin 1 (ANGPT1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Angiopoietin 1 (ANGPT1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 86-97% 93-105% 93-102% 78-101%
EDTA plasma(n=5) 86-98% 84-91% 84-103% 83-90%
heparin plasma(n=5) 93-101% 90-99% 83-99% 97-105%

Stability of the CLIA Kit for Angiopoietin 1 (ANGPT1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Angiopoietin 1 (ANGPT1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Angiopoietin 1 (ANGPT1)

The microplate provided in this kit has been pre-coated with an antibody specific to Angiopoietin 1 (ANGPT1). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Angiopoietin 1 (ANGPT1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Angiopoietin 1 (ANGPT1) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPA008Hu01 Recombinant Angiopoietin 1 (ANGPT1) Positive Control; Immunogen; SDS-PAGE; WB.
RPA008Hu02 Recombinant Angiopoietin 1 (ANGPT1) Positive Control; Immunogen; SDS-PAGE; WB.
RPA008Hu03 Recombinant Angiopoietin 1 (ANGPT1) Positive Control; Immunogen; SDS-PAGE; WB.
PAA008Hu01 Polyclonal Antibody to Angiopoietin 1 (ANGPT1) WB; IHC; ICC; IP.
PAA008Hu02 Polyclonal Antibody to Angiopoietin 1 (ANGPT1) WB; IHC; ICC; IP.
LAA008Hu71 Biotin-Linked Polyclonal Antibody to Angiopoietin 1 (ANGPT1) WB; IHC; ICC.
MAA008Hu23 Monoclonal Antibody to Angiopoietin 1 (ANGPT1) WB; IHC; ICC; IP.
MAA008Hu24 Monoclonal Antibody to Angiopoietin 1 (ANGPT1) WB; IHC; ICC; IP.
MAA008Hu21 Monoclonal Antibody to Angiopoietin 1 (ANGPT1) WB
MAA008Hu22 Monoclonal Antibody to Angiopoietin 1 (ANGPT1) WB; IHC; ICC; IP.
LAA008Hu72 Biotin-Linked Monoclonal Antibody to Angiopoietin 1 (ANGPT1) WB; IHC; ICC.
SEA008Hu ELISA Kit for Angiopoietin 1 (ANGPT1) Enzyme-linked immunosorbent assay for Antigen Detection.
MEA008Hu Mini Samples ELISA Kit for Angiopoietin 1 (ANGPT1) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA008Hu CLIA Kit for Angiopoietin 1 (ANGPT1) Chemiluminescent immunoassay for Antigen Detection.
LMA008Hu Multiplex Assay Kit for Angiopoietin 1 (ANGPT1) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK